Tether Table Aero + Rock Solid Tripod Cross Bar Instructions

Posted by: on Jan 24, 2019

Tether Table Aero + Rock Solid Tripod Cross Bar Instructions

Assembly Instructions:

  1. Unpack your Tether Table, the connector is called the LAJO. The LAJO, plus four screws and an allen wrench are included, they are rolled inside the carrying case, tucked inside the box.

  2. Line up the four holes on the face of the LAJO on the back of the table.

  3. Gently turn the table over while keeping one hand on the connector.

  4. Use the allen wrench to connect the screws on the top side, to the LAJO on the bottom side.

    Now your table is ready to connect in four different ways; to a tripod ballhead via the 1/4″-20 or the Arca Swiss mount, to the base of your tripod via the 3/8″ or to a Low Boy Roller or a Light Stand via the baby stud – OR to a Rock Solid 4-Head Tripod Cross Bar.

How to connect a Tether Table to the Rock Solid Tripod Cross Bar via the 3/8″ on the LAJO bracket.

  1. Line up the Tether Table LAJO 3/8″ female to the 3/8″ male on the cross bar.

  2. Tighten by turning the knurled knob – do not spin the table around on the 3/8″ to connect it, this will damage the rubber pad.

Tips/Warnings

  1. To clean your Rock Solid Tripod Cross Bar, use a damp towel or soft cloth. DO NOT use harsh chemicals or abrasive cleaners.

  2. DO NOT allow children to climb or play on stand or unit. Failure to comply could result in personal injury.

  3. Only use product for its intended purpose. Failure to do so could cause injury and will void warranty.

  4. The Rock Solid Tripod Cross Bar is rated to hold equipment up to 18lbs (8.16kg). However, always refer to maximum load limits on stands and tripods. Those weight limitations ALWAYS take precedence. Exceeding this load limit could cause unit sagging, instability, product collapse and/or serious injury.

Need help? Contact us:

Telephone:

+1 888-854-6565 +1 888-854-6565
+1 480-284-4114 +1 480-284-4114